aqua technix AQUA VARIO Plus OKU Instructions De Montage Et D'utilisation page 21

Operation
Press button "1", "2" or "3" to select the preset
fi xed speed.
If the pump starts from a standstill, it starts up in
priming mode and subsequently with the selec-
ted fi xed speed.
As long as the pump is in the priming phase, the
LED of the selected speed fl ashes.
During running operation the pump is started up
at the fi xed speed directly, without priming time.
The motor is stopped by pressing the button "0".
The "Power" LED fl ashes and the display shows
"OFF".
Setting the fi xed speeds
Press the button of the fi xed speed which is to be
changed and then keep the "SET" button pressed
for at least 3 seconds until the speed displayed in
the display begins to fl ash.
Now the speed can be changed with the buttons
"" "". To save the speed confi rm with "OK".
To cancel and retain the original speed press the
"SET" button.
Note: During the suction phase it is not
!
possible to change the motor speed.
Setting the priming parameters
The motor has to be stopped ("0" button) to pro-
gramme the priming time. Then press the "SET"
button again for at least 3 seconds until the speed
displayed in the display begins to fl ash.
Now the speed can be set with which the motor is
to start up during the priming time.
The speed can be changed with the buttons
"" "" and saved with "OK".
After the priming speed has been set, the length
of the priming time can be specifi ed. The priming
time can be set between 0 (= Off) and 10 minu-
tes.
SET
1 2 3
OK
0
POWER ERROR
WG27.50.113-P
SET
1 2 3
OK
0
POWER ERROR
WG27.50.114-P
SET
1 2 3
OK
0
POWER ERROR
WG27.50.115-P
21 |