Steba Germany LB 10 Mode D'emploi page 14

Preheating
By pressing the button the water will be slightly preheated to guarantee that the
water mist does not withdraw too much temperature from the ambient air. Ener-
gy consumption 100W. The display shows
stopped.
Timer
By pressing the button you can adjust the time up to 9 hours in steps of one hour.
The display shows the symbol
for continuous working.
Humidity
Press the button . The display shows the current humidity. Chose the humidity level
from 40 – 90% und confirm within 3 seconds by pressing once again. The recommen-
ded humidity is 45%-60%. As soon as the device has reached the adjusted humidity in
the room, it switches off.
Sleeping mode
By pressing this button the device works with a humidity of 65 – 70%. Display illumi-
nation and beeping are shut down. As soon as the device has reached the adjusted
humidity in the room, it switches off. By pressing once again the button
ping mode is turns off.
Ionization
By pressing the "Ionization" button the water mist will be enriched with negative
ions. This effect is like after a summer thunderstorm. Quantity of ions per cubic centi-
meter of air:
at high mountain 8000 ion/ccm
at the sea
at the countryside 1200ion/ccm
in the city
in the office only
Water level:
If no water is in the tank, the atomization will be interrupted and the display shows a
LED.
14
. By pressing the button again, the display shows "C"
4000ion/ccm
200ion/ccm
20 ion/ccm
. By pressing once again, the heating is
the slee-