Steba Germany LB 10 Mode D'emploi page 12

∙ Do not direct the air vents on sockets, furniture, books, compu-
ters, etc.
∙ To relocate the appliance, disconnect it from the supply system.
Do not tilt or move during operation.
Cleaning
∙ The appliance must be cleaned more often the harder the wa-
ter is. Too much lime disturbs the correct working of the appli-
ance and leads to the formation of scale. In this case use boiled
or distilled water. In any case do not use carbonated mineral
water!
∙ Unplug
Never immerse the appliance into water.
∙ The appliance must be unplugged and the water must be re-
moved from the base and out of the water tank by opening the
cover at the bottom of the water tank and pour out the water.
Only close the water tank again when the appliance should be
used again, else the water tank should dry up completely.
∙ Scale remains at the base, the transductor and the water tank
should be wiped away. It is essential, that the transductor is
not damaged. When there is excessive scale some scale remover
should be used or fill vinegar in the bassin. After some time,
depending on deposit, the scale dissolved. After this the base
must be cleaned completely with clean water. The filter should
be put into salty water (1 spoon salt per litre) for one day for
recovery. Then rinse the filter with clear water and shake it and
then let it dry.
∙ Steba tipp: Weekly cleaning avoids white sediments. Bacteria
and germs will not have a chance! When the device is regularly
used, its cleaning will be easier and quicker.
∙ Carefully clean the ultrasonic membrane at the bottom part
with a brush. Scale reduces the atomization. Reassemble the
appliance and store in a dry place up till next usage.
12
the appliance first.