Mafell K 65 18M bl Notice D'emploi page 33

Defect
Saw blade jams as the machine is
advanced
Burn marks on the cut surfaces
Chip ejection blocked
Sudden smoke emission from the
motor casing
Cause
Feed rate too fast
Blunt saw blade
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
The saw blade used is unsuitable
for the task or blunt
Wood is too damp
Extended operation
extraction
Overload of the
electronic system
-33-
Elimination
Reduce feed speed
Release the switch immediately.
Remove the machine from the
workpiece and replace the saw
blade
Use parallel stop
Straighten the surface
Replace saw blade
without Connect machine to an external
extraction,
extractor
machine's Interrupt the power supply by
removing the battery pack. The
smoke emission stops.
Do not insert a rechargeable
battery!
smoke!
e.g. portable dust
Avoid inhaling the