Reiner P1-MP Mode D'emploi page 13

5.3. Reactivating the print head
If ink has dried inside the print head
to reactivate it.
Lay the print head down on a firm surface protected by
f
a lint-free cloth or piece of material.
Place the syringe supplied firmly against the opening on top
f
of the print head
(approx. 0.5 ml).
PLEASE NOTE
Posible staining from discharged ink.
Wipe up discharged ink with a lint-free cloth or piece of
f
material.
5.4. Cleaning the print head contacts
In rare cases, dirt on the print head contacts
inferior printing results.
Clean the contacts on the print head
f
a soft cloth or cotton bud, if necessary lightly soaked
in ethanol (spirits).
Disposal
Electrical and electronic waste devices
Waste devices must not be disposed of in the conventio-
nal household waste. They must be returned to a special
collection point for recycling of electrical and electronic
devices.
and carefully inject a small amount of air
4
it may be necessary
4
may result in
7
and in the device with
4
GB
12