Operation with the system remote control (fig. 3):
(7) ON/STBY: Switches the device on when it is in the standby mode. If the LED (fig. 1 (1)) does not illuminate, actuate the power
switch ((fig. 2, (2)) located on the rear. Conversely the device can be switched from power operation to the standby mode.
(8) BT PAIR: Switches the device to the pairing mode when in Bluetooth operation to establish a connection to a Bluetooth
source device. The blue LED status indicator (Fig. 1, (1)) flashes quickly.
(9) LINE 1: Switches the device to the first analogue stereo input (3.5 mm). The turquoise LED status indicator (Fig. 1, (1))
illuminates.
(10) OPT: Switches the device to the optical digital input. The purple LED status indicator (Fig. 1, (1)) illuminates.
(11) BLUETOOTH: Switches the device to the Bluetooth input. The blue LED status indicator (Fig. 1, (1)) flashes or illuminates (see
section System installation - Connecting to a Bluetooth audio source).
(12) LINE 2: Switches the device to the second analogue stereo input (RCA). The green LED status indicator (Fig. 1, (1)) illuminates.
(13) VOLUME: Increases (+) or decreases (-) the volume.
(14) NIGHT Activates or deactivates a playback mode with reduced dynamics and a frequency response that is adapted for sound-
sensitive situations (e.g. late at night). When this mode is activated the LED status indicator (Fig. 1, (1)) will flash green
twice; when it is deactivated it will flash red twice.
(15) MUTE: Switches the sound on and off.
(16) SURR: Switches the 3D surround sound function on or off. Nach dem Einschalten dieses Modus blinkt die LED-Zustandsanzeige
(Abb. 1, (1)) zwei Mal grün, nach dem Ausschalten zwei Mal rot.
EQUALIZER SETTINGS (EQ)
(17) TREBLE: Increases (+) or decreases (-) the volume of high frequencies for manual adjustment of the sound pattern.
(18) BASS: Increases (+) or decreases (-) the volume of low frequencies for manual adjustment of the sound pattern.
(19) MOVIE: Optimises the frequency response of the unit for film sound reproduction.
(20) MUSIC: Optimises the frequency response of the unit for music playback.
(21) VOICE: Emphasises the vocal range for particularly good speech intelligibility.
(22) EQ RESET: Resets all of the changes made to the frequency response (buttons 17 to 21) to a neutral setting. This does not
affect the night mode (14) or the 3D surround sound function (16).
AUTOMATIC SWITCH-OFF FUNCTION
To save power the unit will automatically switch to its standby mode after approximately 15 minutes if no signal is detected at
the input and no commands are issued via the remote control. To reactivate the unit press the ON/STBY button (7) on the remote
control.
SERVICE AND TECHNICAL PROBLEMS
If you should encounter any technical problems, please contact your specialist dealer or Magnat Audio-Produkte GmbH,
Tel.: 02234807-0.
SPECIFICATIONS
Configuration:
Output power RMS/Max.:
Frequency range:
Cross-over frequency:
Standby consumption:
Dimensions (WxHxD):
Weight:
SUBJECT TO TECHNICAL CHANGE
2 ways
1 x 30 + 2 x 15 watts
1 x 60 + 2 30 watts
35 — 22000 Hz
180 Hz
0.45 watts
558 x 74 x 316 mm
4.7 kg
12