Functions - Becker Centronic SunWindControl SWC441-II Notice De Montage Et D'utilisation

MAN/AUTO Sliding Switch
When the sliding switch is set to
DOWN pushbutton commands) are executed and an alarm signal (e.g.: wind
alarm if wind sensor is integrated) given.
When the sliding switch is set to
(e.g. sun protection function, ...).
The automatic sun protection functions are interrupted if a manual operation is
executed during automatic mode. These functions are re-activated automati-
cally when the programmed threshold values are exceeded or undercut after
retraction or via switching the slide switch from "S" to "H" and back to "S".
Channel
The channel of a handheld transmitter can be programmed into one or several
receivers. One or several receivers are controlled via an individual or group com-
mand respectively.
Tool
When used properly, the rib on the handle of the tool serves as an orientation aid
for setting the threshold value.
Rib
1. Insert the tool in the threshold regulator.
2. Turn the threshold regulator as far as the left stop.
3. Remove the tool.
4. Now insert the tool such that the rib points in the minus direction (-).
5. Turn the tool in the plus direction (+) until the desired threshold value is
reached.

Functions

, manual control commands (e.g.: UP, STOP,
, automatic control commands are executed
de
en
fr
nl
17