Pump Description - Cembre CPE-1 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH

2. PUMP DESCRIPTION

socket for connecting the remote hand
C
(
C1
mains cable
plug
F
protection fuses
-
IG
on
off switch i
IR
quick release female hydraulic coupler
IM
transport handle
alarm led
LA
electric motor
MT
hydraulic pump
PO
remote hand controller
PC
PF
remote foot pedal controller
/
PS
oil release
emergency button
QE
electrical panel
(
ft)
3 metre
9.8
TF
3. INSTRUCTION FOR USE
3.1) Setting up
– Carry the pump using the handle (IM) and place
on a flat, stable surface in a dry position.
b
efore operating the pump for the first time
the transport cap with the working cap supplied
– To avoid oil leakage during transportation, the
pump is equipped with an hermetically sealed cap which must be replaced with the working cap
supplied, for correct operation.
– Remove the transport cap and replace it with the orange working cap (TL) complete with dipstick
for oil level verification, tighten firmly.
– Check that the nominal supply voltage corresponds to the value shown on the pump label then
connect to the mains: ON-OFF switch (IG) will light, indicating connection to mains elettricity.
The pump must only be connected to correctly earthed sockets.
– Remove "REMOTE CONTROL" protective cap, connect the remote hand controller to the socket
(C) (see Fig. 4 page 35): tighten the plug (CP) by turning the bezel (G) clockwise until it locks.
– Connect the flexible hose (TF) to the hydraulic head and to the corresponding female coupler
(IR) on the pump (see Fig. 4 and 5).
(Ref. to Fig. 1, page 3)
+
2
phases
earth
o
/
/
oil reservoir
high pressure flexible hose
/
foot pedal controller
)
TL
,
replace
.
FIG. 2
6

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cpe-1-110Cpe-1-mgCpe-1-110-mg

Table des Matières