Table des Matières
Publicité
Anleitung BSTL 800 Profi SPK1
4. TECHNICAL DATA
Nominal voltage:
230 V ~ 50 Hz
Power consumption:
Cutting rate:
500-2800 strokes/min.
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts:
up to 45° (left and right)
Sound pressure level LPA:
Sound power level LWA:
Vibration a w
Double isolation
Weight
5. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
5.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device imme-
diately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
5.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
5.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
13.08.2005
10:07 Uhr
5.4 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Model/type of machine
800 W
Article number of the machine
ID number of the machine
Replacement part number of the required spare
18 mm
part
100 mm
For our latest prices and information please go to
20 mm
www.isc-gmbh.info
10 mm
93 dB(A)
104 dB(A)
6,13 m/s
2
II /
2,4 Kg
Seite 7
GB
7
Publicité
Table des Matières
