Publicité
Les langues disponibles
Les langues disponibles
1 Safety instructions
•
Do not use the press for purposes other than those for which it was designed.
•
Do not work alongside pieces while the ram is moving or when it is under pressure.
•
The safety valve is calibrated and sealed by the manufacturer: Do not attempt to tamper with it and change the setting.
•
Failure to observe these recommendations may cause even serious damage to the press and/or to the persons working with
it.
•
The manufacturer shall not be held liable for damage to persons or things caused by improper use of the press or of its
components.
2 Operation
Position the bed of the press at the desired height:
•
First lift on side of the bed.
•
Insert the pin into the hole at the desired height.
•
Let the bed go down on the pins.
•
Repeat those steps for the other side of the bed.
3 Maintenance
•
Oil the moving parts of the press every six months and check operation of the pressure gauge.
•
Every six months, grease the winch and its ropes. These ropes will have to be inspected visually and possibly replaced if
they are broken or defective.
•
The hydraulic unit (cylinder/pump) is a sealed system that in normal conditions requires only six monthly lubrication of the
moving parts. In the event of the hydraulic unit leaking oil and being dismantled in order to replace the seals, it will be
necessary to add oil through the filler hole on the pump until the pump has been filled up to the level of the hole itself. This
operation has to be done with the ram at rest and therefore fully retracted. The oil in the hydraulic units should anyhow be
replaced every two years independently of the general conditions of the unit. Use hydraulic oil with viscosity from 22° to
25°.
4
M1.3.CAT83010TS.NLFREN 11032019
EN
Publicité
