Peg-Perego Carrello Book 51 S Notice D'emploi page 11

_ WARNING! To avoid injury ensure
that the child is kept away when
unfolding and folding this product.
_ WARNING! Do not let the child play
with this product. This product is
not a toy.
_ WARNING! The assembly and
preparation of the product must be
carried out by an adult.
_ Do not use this product if there are
parts missing or signs of breakage.
_ WARNING! Never leave the child
unattended.
_ Always apply the brake when
stationary and when loading or
unloading children.
_ Do not insert fingers into the
mechanisms.
_ Be careful not to hurt the child
when adjusting the mechanisms
(handlebar, backrest ... ).
_ Any weights hanging on the
handlebar or handles could make
the item unstable; follow the
manufacturer's instructions regards
the maximum loads transportable.
_ Do not load the baskets over 7
Kg. Do not put weight in the cup
holder (if present) in excess of
those indicated on the cup holders
themselves and never hot drinks. Do
not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to
stairs or steps, heat sources, naked
flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or
recommended by the manufacturer/
distributor shall be used.
_ WARNING! This product is not
suitable for running or skating.
_ WARNING! Do not add any
mattress are not approved by the
manufacturer.
_ Do not use accessories which are
not approved by the manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 OPENING: Before opening the frame, remove (without
using blades) any die-cut cardboard.
WARNING:
_ DO NOT PULL OR FORCE THE FASTENER BEYOND ITS
LIMIT.
_ DO NOT USE THE FASTENER AS A CARRY HANDLE OR
TO CARRY WEIGHTS.
DO NOT HANG BAGS OR OTHER ACCESSORIES TO THIS
FEATURE.
Press down the side fastener, hold the upper section of
the handle and rotate it towards you until the frame is fully
opened (fig_a). Open frame (fig_b).
The frame is properly opened when the attachment on the
base clicks into place, as shown.
WARNING: When placing the seat on the frame, press the
seat downwards to ensure it engages securely onto the
base.
2 FITTING THE WHEELS: Slot the uprights into the rear
wheel crosspiece (fig_a), ensuring that it is facing the
right way, then push the rear wheels on and make
sure that they click into place (fig_b). To mount the
front wheels, fit them into the uprights until they lock into
place (fig_c).
3 ASSEMBLY OF THE HANDLE BAR: align the handle bar
with the chassis bars (fig_a) and insert it inside as
shown in the picture.
To fully attach it, press the two side buttons on the
handle bar (fig_b) and push in the handle bar until it
clicks (fig_c).
4 FITTING THE BASKET: if lowered, lift the basket tube to
the horizontal position. Press the silver buttons under
the metal basket tube located at the back of the stroller
(fig_a) and remove the metal tube (fig_b). Thread the tube
through the fabric loop on the back of the basket, making
sure that the two silver buttons are facing downward
(fig_c). Re-attach the tube to the housings (fig_d).
5 Secure the two upper basket vinyl eyelets to the two grey
buttons on either side of the metal tube housing. Please
note that the eyelets open (fig_e). Remove the cardboard
from the lower rear bar.
WARNING:! Secure the two lower basket vinyl eyelets
to the two grey buttons on the top of the lower rear bar.
Please note that the eyelets open (fig_f).
WARNING! If this operation is not performed correctly,
the basket will not properly hold the weight.
Attach the basket tabs to the grey buttons on the front of
the frame (figure).
REFER TO OUR INSTALLATION INSTRUCTIONS VIDEO AT:
WWW.PEGPEREGO.COM
6 FIXED OR SWIVEL FRONT WHEELS Book 51: to fix the
front wheels, rotate the lever counter clockwise to the
locked padlock (fig_a); to release the wheels, turn the
lever clockwise to the unlocked padlock (fig_b). On
difficult terrain, we recommend using fixed wheels.
7 BRAKE: Press the lever down to apply the brake on the
chassis and lift it to release the brake.
8 EXTENDABLE HANDLE BAR: to adjust the height of the
handle bar, pull the levers upwards (fig_a) and slide
up the handle bar until it clicks (fig_b).
The handle bar can be adjusted in different positions.
9 FOLDING UP: The chassis can be folded up without
the seat, with the seat facing the person pushing
(recline the backrest before folding it) or with the seat
facing forward. To fold the stroller, it is best to set
the front wheels to their fixed position and close the
hood (if fitted). Set the handle bar in the lowest position.
(fig_a). Pull the inside handle on the base (fig_b) and lift
it (fig_c); the handle will drop forward until the frame is
closed.
10 To ensure the frame is closed properly, check that
the side fastener is enabled (fig_a). When closed, the
frame remains in the upright position (fig_b).
11 For greater compactness, it is possible to remove the
- 11 -