How To Use; (I) Introduction; (Ii) Blender - Panasonic MK-F500 Instructions De Fonctionnement

BLENDER
Introduction

Ingredient Preparations for Blender
Function Ingredient
Fruit,
Liquidize
Vegetable
How to Use : Blender
1
Insert ingredients into the Blender Jug and close with
the Blender Lid. Attach the Blender Unit onto the Motor
Housing as seen above. Plug-in the plug into the socket
and turn the Rotary Switch to select the speed required.
Note:
• Maximum working capacity: 1 L.
• Prohibited ingredients for Blender Jug: refer to page GB6.
• It is not recommended to blend hard and viscous ingredients. However, if necessary, cut the hard ingredients
into small pieces (e.g. cut carrot into 1 cm³ cubes) and fi ll the Blender Jug with the ingredients not exceeding
half its rated capacity.
• Do not fi ll exceeding the maximum level and reduce ingredients when appliance makes abnormal sound or
vibration during operation.
• Add in soft ingredients (fruits, vegetables) into the Blender Jug before adding in other ingredients.
• If the Cutting Blade gets stuck, switch off immediately and unplug. Do not attempt to proceed to unstuck the
ingredients with your fi ngers, use an object like a rubber spatula instead.
• During blending, there is a possibility that the ingredients will splash out of the Blender Lid hole. In the event
that it splashes out, wipe it off with a dry cloth.
• Do not operate exceeding the rated operation duration (2 min ON, 2 min OFF).
GB18
100_160419_MK-F500_Second_EU(UZ50G155).indb



Max
Speed Operating Time (approx.)
Single Use
2
1,000 mL


18
1. Place the Blender Jug on top of the Motor Housing.
Ensure that the triangle mark on the Blender Jug is
aligned with the triangle mark on the Motor Housing
as seen in Position A.
2. Turn the Blender Jug clockwise until a 'click' sound is
heard. Ensure that the triangle mark on the Blender
Jug is aligned with the rectangle mark on the Motor
Housing as seen in .
To disassemble, follow the assembly steps in
reverse.
~ 2 min
2

After the processing is completed, return the Rotary
Switch to OFF position "0" and unplug from the socket.
Remove the Blender Unit from the Motor Housing and
proceed to remove the ingredients.
Preparation Method
Cut into 1 cm cubes.



2016/04/19 16:58:38