EIBENSTOCK Vakuum Technik Notice Originale page 22

Warranty
According to the general supply conditions for business dealings, suppliers have
to provide to companies a warranty period of 12 months for redhibitory defects.
(to be documented by invoice or delivery note).
Damage due to natural wear, overstressing or improper handling are excluded
from this warranty.
Damages due to material defects or production faults shall be eliminated free of
charge by either repair or replacement.
Complaints will be accepted only if the tool is returned in non-dismantled
condition to the manufacturer or an authorized Eibenstock service centre.
Declaration of conformity
It is necessary that the machine (e.g.: ETN 162/3 or EBM 182/3) used in this drill
rig comply with the requirements which are described in the specifications of the
drill rig (f. e. drilling diameter, fixture of the motor).
We declare that this unit has been designed in compliance with 2006/42/EC.
This unit must not be put into service until it was established that the Power Tool
to be connected to this unit is in compliance with 2006/42/EC (identified by the
CE-marking on the Power Tool).
Vakuum Technik GmbH Eibenstock
Lothar Lässig
General Manager
02.12.2020
Subject to change without notice.
21