EIBENSTOCK Vakuum Technik Notice Originale page 19

Unlocking the carriage:
In order to operate the tool safely, please observe the following notes:
Details of the work area
 Keep the work area free of everything which could obstruct operations.
 Provide for adequate illumination of the work area.
 Adhere to the regulations concerning the power connection.
 Lay the power cable in such a way that any damage by the drill can be
avoided.
 Make sure to always keep the work area in view and to be able to reach all
necessary operating elements and safety installations.
 Keep other persons away from your work area in order to avoid accidents.
Space requirements for operating and maintenance
Whenever possible, keep a free space for operating and maintenance of about
2 m around the drill position, so that you can work safely and have immediate
access in case of a failure.
At the beginning, drill very slowly, since the drill bit does only starts cutting with a
fraction of the cut surface in the material. If you drill too fast or with too much
pressure, the drill bit could get jammed.
Operations
Drilling
To unlock the carriage (1) pull out the lock
knob (2).
To lock the carriage move the carriage
until the locking shaft passes the hole in
the column and jumps into place.
Always lock the carriage when the
assembly is not in use.
18