EIBENSTOCK Vakuum Technik Notice Originale page 18

Attention!
It is important, that the drill rig is firmly connected to the surface. If not fixed
correctly, injuries to the operator or damages to the drilling unit may be
caused.
Uncontrolled movements during drilling will cause the drill bit to hit the
surface to be drilled which may lead to a chipping of the segments. The drill
bit might also tilt in the bore hole which consequently will damage it.
Fixing the core drill motor
Mounting the core drill machine
The machine holder has a special quick connection fixture for the machine
Thereby the prism on the gear box of the machine will be insert from above in
the dovetail fixture of the machine holder and braced firmly by the clamp screw
on the side by means of the turnstile.
For operation with the core drill machine you have to attend
the operating instructions and the safety indications!
Position the drill rig. Position the quick action bracing unit as
close as possible behind the support on the base of the rig.
Fix the drill rig by turning the crank (G) clockwise. Secure in
position by means of the appropriate bolt (H).
Raise the machine holder of the drill rig until
it latches into the end position.
Open the clamp by turning the feed lever until
the clamp releases the guide rail. Insert the
machine into the drill rig as shown.
Secure the machine by tightening the clamp
with the feed lever.
Wear protective gloves!
Caution! When mounting the
machine, risk of squashing!
17