k) Mounting of the Rudder Servo
Mount the servo for the rudder (1) and create
the rope linkage (3) of the rudder with material
from the construction kit.
For precise linkage, the two ropes must be
crossed. Viewed in flight direction, the rope at-
tached to the left rudder horn is located at the
right rudder horn of the servo.
Figure 8, item 2 shows an example for a guide
block that is glued to the fuselage to serve as
a guide for the rudder control ropes and attach-
ment option for the elevator servo cable.
The material required for this is not contain din
the construction kit.
Figure 8
l) Mounting the Throttle Servo
Produce a servo board (1) for the throttle servo
(2) of construction kit parts.
Create a linkage rod (3) of components from
the kit.
The ideal assembly location for the throttle ser-
vo depends on the installation position of the
motor and the linkage point of the carburettor.
The assembly site of the servo in figure 9 thus
only serves illustration purposes and must be
chosen to your own discretion.
Figure 9
41