Husqvarna 530iP4 Manuel D'utilisation page 12

To adjust the angle of the saw head
WARNING: Stop the product and remove
the battery before you continue. Use
protective gloves.
1. Loosen the screws on the saw head (A).
2. Turn the saw head (B) 90°.
3. Tighten the screws (A).
A
B
To assemble the branch hook
• Use 2 screws to attach the branch hook.
To assemble the shock guard
1. Use 6 screws to attach the shock guard.
12
To adjust the length of the shaft
1. Undo the knob.
2. Pull out the shaft to the desired length.
3. Tighten the knob.
To adjust the harness
1. Put on the harness.
2. Attach the harness to the harness support hook.
3. Adjust the length of the harness until the harness
support hook is in level with your right hip.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
783 - 003 - 28.05.2019