Care And Maintenance; Air Filter - Danby Designer DPA110B2WDD Guide D'utilisation Et Soins De Propriètaire

Care and Maintenance

AIR FILTER

UNIT ENCLOSURE
LONG TERM
STORAGE
Fig.25
Upper filter
(Take out)
Remove the
screw ,then
take the lower
filter out.
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, paint thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose. This
will cause deterioration of electrical components and wiring
insulation.
4) If the power cord is damaged, it cannot be repaired and must be
replaced with a new cord from the product manufacturer.
Clean the air filter at least once every two weeks. Accumulation of dust
will hinder fan operation.
REMOVAL
This unit has two filters. Lift the upper filter out in the direction of the
arrow (Fig. 25), then down. Remove the lower filter by loosening the screw
and lifting out the filter as shown in Fig. 25.
CLEANING
1) Wash the air filter by submerging it gently in warm water (about 40°C /
104 °F) with a neutral detergent.
2) Rinse the filter and let it dry.
REINSTALL
Install the upper air filter after cleaning , and install the lower filter after,
using the screw (see Fig. 26). *Filters should be dry before installing.
Use a lint-free cloth soaked with neutral detergent to clean the unit
enclosure. Finish with a dry clean cloth.
Remove the rubber plug at the back of the unit and attach a hose to
the drain outlet. Place the open end of the hose directly over the drain
area in your basement floor (see page 14).
Remove the plug from the bottom drain outlet, all the water in the bottom
tray will drain out (see page 14).
Keep the appliance running on FAN mode for half a day in a warm room
to dry the appliance inside and prevent mold from forming.
Stop the appliance and unplug it, wrap the cord and bundle it with tape.
Fig. 27.
Remove the batteries from the remote controller.
Clean the air filter and reinstall it.
Fig.26
Upper filter
(Install)
Install the
lower filter
by using
the screw.
15
IMPORTANT
Fig.27
Buckle
Power
cord
Power plug
Power plug socket