Baumer CombiLyz AFI4 Manuel D'utilisation page 12

CombiLyz AFI4/AFI5
Inductive conductivity transmitter
Select conductivity range.
f
„
Menu
AFIx menu
If desired, select or define further settings:
f „
Concentration output
„ „
Display colors
„ „
Warnings
„ „
Relays
„ „
8.2 Configuration via FlexProgram
9 FlexProgrammer 9701 is connected.
Configuration options with the AFIx transmitter:
Select HART or IO-Link mode
„ „
Configure switch output
„ „
Configure temperature compensation
„ „
Select temperature source for compensation
„ „
Select conductivity range
„ „
Set current limits
„ „
Select concentration output
„ „
Configure media screen
„ „
Make a data logging
„ „
Calibrate sensor and media
„ „
Configuration options with the DFON display:
Select screen layout
„ „
Select backlight intensity
„ „
Define relays
„ „
Define warning and error indication
„ „
Calibrating the sensor (conductivity/temperature)
9 AFIx is powered up
9 The used medium has a known conductivity/temperature
Adjust an offset for the conductivity/temperature for the sensor.
f „
If necessary, reset the sensor offset in FlexProgram.
f „
Calibrating a medium
For the different ranges it is possible to calibrate the medium by calculating the temperature compensation
after 3 measurements.
9 Calibration is done in a controlled environment
9 AFIx is powered up
Have the sensor tip immersed in the medium for 1 minute before measuring the conductivity.
f „
Measure the conductivity at 3 different temperatures using the same medium.
f „
Calculate the temperature compensation for the medium.
f „
For further information, refer to the HELP section in FlexProgram.
12 / 52
Conductivity measurement
Input con g. Conductivity ranges
Operating Instructions
Conductivity range 1
Conductivity range 2
Conductivity range 3
Conductivity range 4
Select range
Select range
Select range
Select range
www.baumer.com