TFA 30.3034 Mode D'emploi page 6

TFA_No_30.3034_m_Funkuhr_Anleit
RATIO
– Wireless thermometer
1. Introduction
This new wireless thermometer consists on a base station with
indoor sensors for room temperature and a remote sensor for
measuring outdoor temperature.
So you get useful information about temperature in and around
your house. This is fun and makes you curious to know more.
Please read this instruction manual carefully and keep it!
1.1 Content
• Display unit
• Outdoor thermo sensor
• Instruction Manual
1.2 Functions
• Outdoor temperature wireless (433 MHz), distance range up to
100 m (free field)
• Expandable up to 3 outdoor transmitters, also for the tempera-
ture control of remote rooms, e.g. children's room, wine-cellar
• Indoor temperature
• Maximum and minimum values
• Radio-Controlled clock
• For wall mounting or table standing
• Very simple installation, no cables required
2. Elements (Fig. 1)
2.1 Receiver (Display unit)
LCD
A1: Clock
A2: Indoor temperature
A3: Outdoor temperature
A4: Outdoor temperature wave icon
A5: Channel number
Buttons
B1: "SET"/"MIN/MAX" button
B2: "RESET"/"CH/+" button
10
14.07.2008 13:56 Uhr Seite 6
RATIO
– Wireless thermometer
Housing
C1: Wall Mount Hole
C2: Battery Compartment
C3: Stand (fold out)
2.2. Transmitter (Fig. 2)
D1: Wall Mount Hole
D2: Battery compartment
D3: Support for table standing
D4: Support for wall mounting
3. Getting started
3.1 Insert batteries
• Open the battery compartment of the display unit and the
transmitter (screwed) and place both instruments on a desk
with a distance of approximately 1.5 meter. Check that no other
electronic devices are close.
• Insert the batteries 2 x 1,5 V AAA into the battery compartment
of the transmitter and immediately afterwards 2 x 1,5 V AA in
the display unit, observing the correct polarity.
3.2 Reception of outdoor temperature
• The display unit automatically starts scanning the 433 MHz signal
to register the thermo sensor unit after batteries are inserted.
flashes on the LCD of the display unit.
• Note: DO NOT PRESS ANY KEY during the learning period.
After outdoor temperature is displayed you can place your
remote sensor outdoors at the final destination. If the outdoor
temperature is not displayed or if any key is pressed before the
outdoor temperature signal is received and when changing
batteries you will need to follow the battery installation pro-
cedure again. Please wait 10 seconds before inserting the
batteries again.
3.3 Radio controlled time reception
• The clock will scan the DCF frequency signal (max. 10 min.) and
the DCF symbol flashes on the LCD.
• When the signal is received successfully, the radio controlled
time and the DCF symbol appear permanently.
11