Adjust Leveling Legs; Complete Installation Checklist; Electric Models; All Models - Whirlpool WGD7990X Instructions Pour L'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.

Adjust leveling legs

If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once the dryer is level, make sure all four legs are snug
against the floor.
COMPLETE INSTALLATION
CHECKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Be sure the water faucets are on.
q
Check for leaks around "Y" connector, faucet, and hoses.
q
Check dryer's final location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See "Level Dryer".
q
Remove film on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
q
Read "Dryer Use" in your "Use and Care Guide".
q
If you live in a hard water area, use of a water softener
is recommended to control the buildup of scale through
the water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.

Electric Models:

q
Plug into a grounded outlet.
Gas Models:
q
Check that gas supply is on.
q
Check for leaks.

All Models:

q
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Start button has been pushed firmly.
• D ryer is plugged into an outlet and/or electrical supply
is connected.
• H ousehold fuse is intact and tight, or circuit breaker
has not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.

TROUbLESHOOTINg

See the "Use and Care Guide" or visit our website and reference
Frequently Asked Questions to possibly avoid the cost of a
service call.
15

Publicité

Table des Matières
loading

Table des Matières