Installation Requirements; Tools And Parts - Whirlpool WGD7990X Instructions Pour L'installation

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" nut driver
(recommended)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tape measure
Level
4
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Utility knife
Pliers
Caulking gun and
compound (for installing
new exhaust vent)
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied (all models):
Leveling legs (4)
Short inlet hose
Rubber washer
Parts package is located in dryer drum. Check that all parts
are included.
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom you
purchased your dryer. For further information, please reference
the "Assistance or Service" section of the "Use and Care Guide".
8" or 10" adjustable wrench
(for gas connections)
"Y" connector
Long inlet hose