Mitsubishi Electric Mr. Slim PLA-A12EA7 Manuel D'utilisation page 8

. Operation
. . Fan spee setting
Fri
83
Room
F
Cool Set temp.
83
F
Mode Temp. Fan
F1 F2 F3 F4
Press the [F4] button to go through the fan speeds in the following order.
units.
Notes:
The nu er of a aila le fan spee s epen s on the type of unit
connecte .
In the follo ing cases the actual fan spee generate
ill iffer fro the spee sho n the re ote controller isplay.
1. While the isplay is in STAND Y" or DEFROST" states.
2. When the te perature of the heat e changer is lo
ing o e.
e.g. i e iately after heating operation starts
In HEAT o e hen roo
perature setting.
. When the unit is in DRY o e.
.5. Air o irection setting
.5.1 Na igating through the Main
Accessing the Main enu
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
Ite selection
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Cursor
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
Auto
y the unit
in the heat-
te perature is higher than the te -
enu
Press the [MENU] button.
The Main menu will appear.
Press [F1] to move the cursor down.
Press [F2] to move the cursor up.
Na igating through the pages
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
Sa ing the settings
OU silent mode
Mon Tue Wed Thu Fri Sat Sun
Start Stop Silent
-
Setting display:
day
F1 F2 F3 F4
E iting the Main enu screen
Fri
Room 83
F
Cool Set temp.
83
F
Mode Temp. Fan
F1 F2 F3 F4
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will
be lost.
Display of unsupporte functions
Title
Not available
Unsupported function
Return:
F1 F2 F3 F4
page
Press [F3] to go to the previous page.
Press [F4] to go to the next page.
Select the desired item, and press
the [SELECT] button.
The screen to set the selected item
will appear.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
The message at left will appear
if the user selects a function not
supported by the corresponding
indoor unit model.