Mitsubishi Electric Mr. Slim PLA-A12EA7 Manuel D'utilisation page 10

. Operation . Operation
Manual ane angle Wire re ote controller
Main Main menu
Maintenance
Initial setting
Service
Main display:
Cursor Page
F1 F2 F3 F4
Maintenance menu
Auto descending panel
Manual vane angle
3D i-See sensor
Main menu:
Cursor
F1 F2 F3 F4
Manual vane angle
Ref. address
Unit No.
Identify unit Check button
Input display:
Cur. Address Check
F1 F2 F3 F4
Manual vane angle
Select:
Outlet Angle
F1 F2 F3 F4
Manual vane angle
Setting
F1 F2 F3 F4
Note:
Do not set the raft re uction in an en iron ent
Other ise con ensation ay for
1
1 Select "Maintenance" from the
Main menu (refer to page 8), and
press the [SELECT] button.
2 Select "Manual vane angle" with
the [F1] or [F2] button, and press
the [SELECT] button.
3 Move the cursor to "Ref. address"
or "Unit No." with the [F1] button
to select.
Select the refrigerant address
and the unit number for the units
with the [F2] or [F3] button, and
press the [SELECT] button.
-
dress
the unit.
The vane of only the target
indoor unit is pointing downward.
4 The current vane setting will ap-
pear.
Select the desired outlets from
1 through 4 with the [F1] or [F2]
button.
3, 4, (all outlets)"
Press the [F3] or [F4] button to
go through the option in the order
of "No setting (reset)", "Step 1",
"Step 2", "Step 3", "Step 4", "Step
5" and "Draft reduction*".
Select the desired setting.
* Draft reduction
ting is more horizontal than the
setting in order to reduce a drafty
feeling. The draft reduction can
be set for only 1 vane.
ith high hu i ity.
an rip.
ane setting
No setting
Step 3
Draft
reduction*
Press the [SELECT] button to save the settings.
A screen will appear that indicates the setting information is being trans-
mitted.
The setting changes will be made to the selected outlet.
The screen will automatically return to the one shown above (step 5)
when the transmission is completed.
Make the settings for other outlets, following the same procedures.
If all outlets are selecte
the unit goes into operation.
Navigating through the screens
To go back to the Main menu ................ [MENU] button
To return to the previous screen .......... [RETURN] button
-
Step 1 Step 2
Step 4 Step 5
All outlets
ill e isplaye the ne t ti e