Speci Cations - Mitsubishi Electric Mr. Slim PLA-A12EA7 Manuel D'utilisation

7. Trou le Shooting
Having trouble?
Nothing appears in the wireless remote controller display, the display
is faint, or signals are not received by the indoor unit unless the remote
controller is close.
The operation lamp near the receiver for the wireless remote controller on
the indoor unit is blinking.

. Speci cations

Model
Power source
<V / Hz>
Rated Input
<kW>
Rated Current
<A>
Heater <kW>
Height dimension <inch>
Width dimension <inch>
Depth dimension <inch>
<m
Noise level
<dB>
Net weight <lbs>
16
PLA-A12EA7 PLA-A18EA7
0.02/0.02 0.03/0.03
0.26/0.21 0.34/0.29
–
3 / min> 12-13-14-15 13-14-16-17
27-28-29-30 28-29-31-32
46 (11)
Here is the solution. (Unit is operating normally.)
The indoor operation sound level is affected by the acoustics of the
particular room as shown in the following table and will be higher than
High sound
absorbing rooms
Broadcasting
Location
studio, music
examples
room, etc.
Noise levels 3 to 7 dB
The batteries are low.
Replace the batteries and press the Reset button.
If nothing appears even after the batteries are replaced, make sure that
the batteries are installed in the correct directions (+, –).
The self diagnosis function has operated to protect the air conditioner.
Do not attempt to repair this equipment by yourself.
Turn off the power switch immediately and consult your dealer. Be sure
to provide the dealer with the model name.
PLA-A24EA7 PLA-A30EA7
Single 208/230/60
0.05/0.04 0.06/0.05
0.49/0.44 0.59/0.54
– –
10-3/16 (1-9/16)
33-1/16 (37-3/8)
33-1/16 (37-3/8)
15-18-20-23 15-18-20-25
28-30-33-36 28-32-35-38
Low sound
Normal rooms
absorbing rooms
Reception room,
hotel lobby, etc. room
6 to 10 dB 9 to 13 dB
PLA-A36EA7 PLA-A42EA7
0.10/0.09 0.11/0.10
0.98/0.93 1.05/1.00
– –
11-3/4 (1-9/16)
19-24-29-34 21-26-30-34
32-37-41-44 34-38-42-45
56 (11)
–