Using Grass Bag; Setting Height-Of-Cut - Toro Recycler 48 Mode D'emploi

2. Open discharge door and insert plug into
discharge tunnel opening (Fig. 10).
3. Push plug all the way into the discharge tunnel
opening.
4. Lower discharge door over plug.
5. To remove the plug, raise discharge door and
pull plug out of discharge tunnel.

Using Grass Bag

1. Stop engine and wait for all parts to stop.
2. INSTALLING BAG—Raise discharge door,
slide bag ramp attached to bag into discharge
opening, and hook bag frame onto mounting
bracket (Fig. 11). Allow discharge door to rest
on top of bag (Fig. 12).
Note: Make sure grass bag door is fully
closed against grass bag before
installing bag on mower.
3. REMOVING BAG—Stop engine and wait for
all moving parts to stop. For protection, always
keep hands and feet away from mower housing
while engine is running. Raise discharge door.
While holding discharge door up, grasp handle
on grass bag and lift bag off mower. Allow
discharge door to close.
Note: When removing the grass bag, the bag
ramp scoops out any clippings that
may be plugging the discharge
opening. If the discharge opening
remains plugged, clear all clippings
from the mower.
4. EMPTYING BAG—Grasp bag frame handle
and rear of grass bag. Tip bag door up and
gradually tip bag forward to empty clippings.
POTENTIAL HAZARD
Grass clippings and other objects can be
thrown from an open discharge tunnel.
WHAT CAN HAPPEN
Objects thrown with enough force could
cause serious personal injury or death to
operator or bystander.
HOW TO AVOID THE HAZARD
Never open door on discharge tunnel when
engine is running unless the grass bag or
discharge tunnel plug is securely installed.
POTENTIAL HAZARD
A worn grass bag could allow small stones
and other similar debris to be thrown in
operator's or bystander's direction.
WHAT CAN HAPPEN
Thrown objects can cause serious personal
injury or death to operator or bystanders.
HOW TO AVOID THE HAZARD
Check the grass bag frequently. If it is
damaged, install a new genuine TORO
replacement bag.

Setting Height-of-Cut

Toro's exclusive SmartWheel provides a simple
method for determining the proper cutting height.
The SmartWheel has two cutting scales —
SPARSE/NORMAL and LUSH — to ensure the best
height-of-cut setting in any mowing condition. Use
the SPARSE/NORMAL scale during the warm
summer season for the majority of your mowing. The
LUSH scale is for thick, moist, succulent grass that
grows most often in the spring.
In general, it is recommended that:
Grass length should usually be cut at the C, D or
E settings or MAINTAINED at two to three
inches in height.
GB–11