Changing The Blade - QEP 83250Q Manuel D'utilisation

maKinG a diaGOnaL CUt
1 . Follow the same procedure for a straight cut .
2 . Loosen the nut on the squaring tool, and
position the tile diagonally .
3 . Lock the nut and perform the cut following
procedure for a straight cut .
anGLed Or 45 deGree CUtS
1 . Loosen the two knobs at either end of the
bridge (Fig 11)
.
figure 11
2 . Tilt bridge to the desired angle up to 45 degrees
(Fig 11) . Tighten knobs at either end of bridge,
and proceed with cutting tile following same
procedure as listed in the "straight cut"
section .

CHanGinG tHe BLade

SUPPLY BEFORE MAkING ADJUSTMENTS,
MAINTENANCE, CLEANING OR REPLACING THE
BLADE!
1 . choice of the saw blade. Only use 8 Inch
continuous rim or turbo blades with a 5/8 Inch
arbor .
DISCONNECT THE POWER
2 . replacing the saw blade
A . Loosen the blade guard thumb screw
(Fig 12) .
figure 12
B . Use the hexagonal wrench to hold the
blade nut and use the spanner wrench
provided to hold the shaft . Loosen the nut
turning clockwise as in (Fig 13) .
C . Ensure that the shaft and flanges are
clean . Mount blade back on to shaft
ensuring that the directional arrow on the
blade is rotating towards the material to
be cut .
D . Insert flange and lock nut . Tighten
counterclockwise .
figure 13
– 8 –