Bluetooth - Kenwood KDC-X597 Mode D'emploi

BLUETOOTH®
You can operate Bluetooth devices using this unit.
Connect the microphone
MIC (Microphone
Microphone (supplied)
input terminal)
Rear panel
If you turn off the unit or detach the control panel during a phone
call conversation, the Bluetooth connection is disconnected.
Continue the conversation using your mobile phone.
Supported Bluetooth profiles
Hands-Free Profile (HFP) / Serial Port Profile (SPP) / Phonebook
Access Profile (PBAP) / Object Push Profile (OPP) / Advanced Audio
Distribution Profile (A2DP) / Audio/Video Remote Control Profile
(AVRCP)
Pair a Bluetooth device
When connecting a Bluetooth device to the unit for the first time,
perform pairing between the unit and the device. Once the pairing
is completed, the Bluetooth device will remain registered in the unit
even if you reset the unit.
• Up to five devices can be registered (paired) in total.
• A maximum of two Bluetooth phones and one Bluetooth audio
device can be connected at any time.
10
• This unit supports Secure Simple Pairing (SSP).
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect the
1
2
3
Secure using cord clamps (not • For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
supplied) if necessary.
• Pairing request (via Bluetooth) is automatically activated if an iPhone/iPod touch is connected
Adjust the
microphone angle
You can check the connectivity of the supported profile between the Bluetooth device and the
unit.
1
2
3
4
• To cancel, press
device to the unit manually. Refer to the instruction manual of the Bluetooth device for more
information.
Press L SRC to turn on the unit.
Search and select this unit model name (KDC-X5**/ KDC-BT5**U/ KDC-BT3**U) on the
Bluetooth device.
"PAIRING" \ "PASS XXXXXX" \ Device name \ "PRESS" \ "VOLUME KNOB" scrolls on the
display.
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed and "BT" will light up when the Bluetooth
connection is established.
code immediately after searching.
through the USB input terminal. (Applicable only if [AUTO PAIRING]/ [AUTO PAIR] is set to [ON].)
(➜ 12)
Press the volume knob to pair once you have confirm the passcode.
Bluetooth test mode
Press to enter Bluetooth mode.
Turn the volume knob to select [BT TEST MODE]/ [BT TEST], then press the knob.
"PLEASE PAIR YOUR PHONE" appears.
Search and select this unit model name (KDC-X5**/ KDC-BT5**U/ KDC-BT3**U) on the
Bluetooth device.
Press the volume knob to start pairing and begin the test mode.
"PAIRING" flashes on the display.
The connectivity result (OK or NG) appears after the test.
PAIRING : Pairing status
HF CNT: Hands-Free Profile (HFP) compatibility
AUD CNT: Advanced Audio Distribution Profile (A2DP) compatibility
PB DL: Phonebook Access profile (PBAP) compatibility
.