Publicité
Les langues disponibles
Les langues disponibles
Prior to putting the tool into operation, check the mains voltage for
conformity with the requirements of the tool's nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
Use only extension cable with sufficient cross-section (min. 2,5 mm
cross-section which is to small could lead to excessive power loss and to
overheating the motor and the cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Additional Handle
For manual drilling, the ETN 162/3 may be used only together
with its additional handle which comes with the tools.
Place it on the gearing collar from the front and fix it by
turning the handle in direction of the arrow.
Switching ON and OFF
Short-time operation
ON:
Press the ON/OFF switch
OFF:
Release the ON/OFF switch
Long-time operation
ON:
Keeping the ON/Off switch pressed, push in the arrestor button.
OFF:
Press and release the ON/OFF switch again.
Attention!
Use the arrestor button only during operation with drill rig.
!
Its use during manual operation is not allowed.
If the machine stops for any reason or due to power failure,
immediately release the arrestor button by pressing the
ON/OFF switch.
If this button is not released, the tool may unintendedly
restart if the PRCD protective switch is operated and cause a
danger to the user.
Cross section in sq. mm
1.5
20 m
50 m
21
2
). A
2.5
40 m
80 m
Publicité
