Safety Precautions - Chauvin Arnoux F 15 Mode D'emploi

Table des Matières

Les langues disponibles

Meaning of the symbol

Caution! Read the instruction manual before using the instrument. In this

manual, safety instructions prefixed with this symbol will, if not observed or

followed, bring hazardous conditions for the operator or for the instrument

and installation.

Thank you for purchasing a CLAMP MULTIMETER.

To obtain the best service from this instrument :

- read the instruction manual carefully

- respect all necessary precautions that are required in the use of this instrument.

SAFETY PRECAUTIONS

Check that the switch is in the correct position, and the leads if applicable, before

any measurement.

Check the correct alignment of the conductor in relation to the markings, and that

the jaws close correctly.

Do not use the clamp on cables or conductors at a voltage of more than 600 V.

Do not use the clamp for currents greater than 1000 A AC and 1400 A DC.

Do not make measurements of resistance, continuity test or diode test on a live

circuit.

Always disconnect the clamp from any electric source before changing the battery.

Set the switch to the OFF position when you are not using the clamp.

ENGLISH

Table des Matières

Table des Matières