Description of adjustable components
Illustration (open side)
1. Analog display with different colored indicating ranges 6 V/12 V
2. Zero-point correction (indicator zero position)
3. Toggle switch with automatic delay for measurement
4. Red terminal clamps for positive terminal (+) and black for nega-
tive terminal (-) of the battery
5. Cooling slots for shunt
Caution!
Observe maximum input values.
Contents list
Introduction ....................................................................................16
Intended use ..................................................................................17
Adjustable components (end side) ................................................18
List of contents ..............................................................................18
Safety instructions ..........................................................................19
Use of lead battery tester ..............................................................21
Measurement procedure ................................................................22
Disposal ..........................................................................................26
Maintenance ..................................................................................26
Technical data and measurement tolerances ................................27
18
Technical data and measurement
tolerances
Technical data
Display
Test current
Voltage measu-
rement range
Running voltage range
Red area 6 V/12 V
Yellow area 6 V/12 V
Green area
(1000
Operating temperature
Storage temperature
Relative humidity
Dimensions (L X B X H)
* CCA = Cold Cranking Amps = cold starting current
: Analog gauge with zero-point
correction
: approx. 100 A of 5% at 13.2 V
: approx. 0 to max. approx. 16 VDC
(direct voltage)
: approx. 0 to max. approx. 16 VDC
: < 4.6 V/< 7 to 9 V
: 4.6 to 5.8 V/9.0 to 11.2 VDC
: 5.8 to 7 V/9.4 (200 CCA*) to 12.8
CCA*) V
: 0° C to +55° C
: -20° C to +70° C
: max. 80%, non-condensing
: approx. 295 x 160 x 80 mm
(without lines)
27