britech BT 36 Mode D'emploi page 35

PETROL CHAIN SAW FOR TREE SERVICE USER MANUAL
STOPPING THE ENGINE
1) To stop the engine, lower the lever (C) (fig.35)
to position . When a clicking noise is heard,
STOP
the engine has stopped correctly.
Fig.35
A
C
STOP
2) After using the chain saw for long periods of
time, it is advisable to let the engine run at idle
speed (lever fig.34 item B released) for several
seconds before operating the "
lever.
WARNING! Familiarise yourself with
the operation of the stop switch lever
in order to act promptly in emergencies.
WARNING! The chain will continue to
move for some time after the throttle
lever is released.
STARTING A WARM EN-
GINE
1) Start the engine with le-
ver (C) in position (I).
STARTING A WARM ENGINE AFTER REFU-
ELLING
1) If the fuel tank is completely empty, after refu-
elling, restart the engine by following the instruc-
C
B
" switch
STOP
C
I
tions given in the paragraph "STARTING A
COLD ENGINE ".
STOPPING THE ENGINE. The engine must
ALWAYS be stopped in the following cases:
# When refuelling
# When oiling the chain
# When carrying out checks and repairs
# When cleaning and adjusting the chain saw
# When moving the chain saw in the working
area
# When the chain saw is left unattended
# During transport
8. CHAIN SAW OPERATION
- When necessary, this
special type of chain saw
may be used with a single
hand by a trained operator who is using a
correct and safe working method to prune
trees and remove branches; all other op-
eration, on the other hand, must be carried
out 2 hands, as required with a traditional
chain saw (fig.11-A).
- Comply with all safety rules described in
chapter "SAFETY".
- Cut the tree by pushing the throttle lever
all the way and come into contact with the
wood after the engine has reached full
speed.
8.1 USING THE CHAIN SAW ON TREES WITH
ROPES AND SLINGS
The following instructions are only
examples of how to use the chain
saw in the best possible way: however, all
current local and national laws must always
be complied with.
35