Controls And Indicators - Kenwood SW-508ES Mode D'emploi

Controls and indicators

1 Power on / standby indicator
This indicator indicates operation mode when it lights in green,
and the Standby mode when it lights in red.
2 POWER switch
Switches the power ON and OFF .
3 VOLUME control knob
Adjusts the volume level of the output of the Subwoofer. Ro-
tating the knob clockwise increases the volume level, and ro-
tating the knob counterclockwise decreases the volume level.
4 TURNOVER switch
Set this switch (to ON or OFF) according to the output signal
from the amplifier or receiver which is to be connected with
the Subwoofer.
ON: To help the Subwoofer manifest its performance most ef-
fectively with an ordinary subwoofer pre-out signal or line-level
signal, this position cuts the other components than the low
frequency component so that only the bass sound is repro-
duced through the Subwoofer.
OFF: The subwoofer output signals from these amplifier or re-
ceiver are customized to cut other components than the re-
quired low frequency component in an optimum manner ac-
cording to the current sound mode in use. When the Subwoofer
is combined with one of these amplifier or receiver, the TURN-
OVER switch should be set to OFF: The Subwoofer does not
apply electrical filtering to the input signal and reproduces it
faithfully through the loudspeaker.
TURNOVER function does not work when the TURNOVER
switch is OFF.
5 TURNOVER control knob
Ajusts the balance between the bass from the front speakers
and the bass from the Subwoofer.
Standby mode
While the on/standby indicator is lit in red, a small amount
of power is supplied to the system. This is called standby
mode.
POWER VOLUME TURNOVER
1
ON OFF MIN MAX 60Hz 200Hz ON OFF
2
3
7
4
SPEAKER INPUT
R L
AUTO SHUT OFF
ON OFF
R L
LINE INPUT
SPEAKER OUTPUT
6
5
Example of standard adjustment according to the type of
front speakers.
Front speaker
Small speaker
Medium speaker
Large speaker
Depending on the listening room condition and the front
speaker characteristics, other adjustment setting than the ex-
amples shown above may provide more natual bass sound and
more effective bass reproduction. Try various adjustment set-
tings to select the optimum one for your listening room.
TURNOVER function does not work when the TURNOVER
switch is OFF.
6 SPEAKER OUTPUT terminals 5
7 SPEAKER INPUT termnals 5
8 LINE INPUT jack 5
9 AUTO SHUTOFF switch
Switches AUTO SHUTOFF mode ON and OFF .
ON: The Subwoofer automatically returns to Standby mode
(red light) when no signal has been input for about 10 minutes.
The Subwoofer automatically enters operation mode when a
signal is input during Standby mode.
0 Power cord 5
Caution concerning operation
An excessive input level to the Subwoofer may impair the sound
quality or damage the unit. Careful attention should therefore
be paid to the following precautions.
Notes:
1. Do not increase the output of the amplifier or receiver to a
high level while the low-frequency level is enhanced by
the amplifier's tone control or loudness control.
2. When operating the amplifier or receiver switches or when
placing the stylus on an analog record, set the amplifier or
receiver volume to its minimum level.
8
9
0
Turnover Frequency
120~200 Hz
80~120 Hz
60~80 Hz
7
EN