Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Pairing sensor with Base
1. Start App.
2. Expand menu "Dashboard"
"Add Accessory"
3. Scan the QR code, printed on this
accessory.
4. The APP will auto recognize this accessory
and add it to your list. Rename it with a
perspicuous name, which says you the
exact location of the sensor in case of
alarm, e.g. "Bathroom".
5. Test Alarm function e.g. by triggering
an SOS alarm.
WATER 2060
BURGprotect_WATER2060_03-2019.indd 9
–>
–>"Scan QR Code"
Battery replacement instructions
1. Insert the fl at blade of a small screwdriver
into the pry-off slot of transmitter, twist
the blade to remove the cover.
2. Replace the 1 x CR2032 (3V) battery and
then close the cover.
Correct location for installation
The radio signal of the sensor is highly
dependent on environmental conditions.
Metal objects, concrete surfaces, walls, and
metal cables all reduce its range, etc. Other
radio devices and environmental conditions
can also interfere with its operation.
IMPORTANT NOTE: The alarm can only
work as well as permitted by its
installation and environment. The alarm
can indicate dangerous situations but
it cannot prevent them.
The device must not be painted, varnished
or altered in any way.
English | 9
09.04.2019 11:54:0
Publicité
Table des Matières
