Battery Replacement Instructions - Burg Wächter BURGprotect MOTION 2010 Notice D'installation Et D'utilisation

Battery replacement
instructions
1. Open the sensor housing by pressing
the ratched mechanism.
2. Change batterie and close housing
Correct location for installation
The radio signal of the sensor is highly
dependent on environmental conditions.
Metal objects, concrete surfaces, walls, and
metal cables all reduce its range, etc. Other
radio devices and environmental conditions
can also interfere with its operation.
IMPORTANT NOTE: The alarm can only
work as well as permitted by its
installation and environment. The alarm
can indicate dangerous situations but
it cannot prevent them.
The device must not be painted, varnished
or altered in any way.
MOTION 2010
BURGprotect_MOTION 2010_03-2019_02.indd 11
Sensor
On/Off
Installation & Notice
• Open the case and remove the battery
insulative strip.
• Pairing with main panel by App before
installing.
• Fix the bracket with double-side sticky
tape or screws on wall, connect the
sensor to bracket and adjust a proper
angle. 360° solid angle adjustment is
easily available with connection of bead
and magnetic slice.
• Recommended to install at height of
1.8 - 2.5m from ground
0m 1,2m-1,5 m3m
• Indoor use only. Avoid installing the
sensors in area with strong light,
temperature changes rapidly or the air
stream flows frequently, like close to
windows, air conditioner, refrigerator,
heater, oven, and large obstacles
• Avoid installing two sensors in the same
detection scope to interference.
• The sensor is more sensitive to the cross
movement than to the vertical
movement, so the preference of sensor is
best when the detection direction is
vertical to the walking direction of people
6m 9m 12m
English | 11
10.04.2019 16:37:5