Assembling note: During installation, please regard that the solar cells
face the sun or resp. that as much light as possible meets the cells.
Please stick the house number according to your wishes onto the panel as
seen in the figure on page 1. To assure an ideal adhesion, the temperature
should not be under 5 °C.
3. Changing the battery
Every battery is a wearing part, whose durability depends on the use,
as e. g. on the number of charge cycles or charge times. With very low
temperatures, the functionality of the battery can in some circumstances
slightly be limited.
If you have to change the battery, open the door and loosen the screw
that fixates the battery case lid.
Figure 3: Opening the battery case lid
Exchange the battery. Only NiMH batteries with a capacity of approx.
60 – 1000 mAh are usable.
Please consider the polarity during an exchange of the battery.
(Labelling (labeling) inside the battery case.)
Figure 4: Inserted battery
Apply the battery case lid again and screw it in place.
nel
Solarpanel
English | 7