Before You Use; Handling Precautions - Elmo MX-P Guide De Démarrage Rapide

BEFORE YOU USE

■ Be sure to use the cable supplied with the product.
■ The supplied power cord and AC adapter are designed for exclusive use with this product.
Do not use them with other products.
■ Be sure to use the power cord applicable to your local power specifications. If the product
was sold in Japan, use the AC adapter sold with the product with 100 VAC and 50 or 60
Hz.
■ When storing the product, do not leave it under direct sunlight or by heaters. It may be
discolored, deformed, or damaged.
■ Do not place this product in any humid, dusty, salt bearing wind, or vibrating locations.
Use it under the following environmental conditions:
Temperature：0℃～ 40℃
■ Use a soft, dry cloth for cleaning. Do not use any volatile solvent such as thinner or
benzene.
■ Luminescent and Black Spots
日
There may be some pixels that do not properly operate due to the use of CMOS Area
本
Image Sensors made-up of many pixels.
語
Though luminescent or black spots may be found on the screen, it is a phenomenon
peculiar to the CMOS Area Image Sensors and is not a malfunction.
■ Follow the guidelines below to prevent the unit from dropping or overturning.
・ Use the product on a stable base, desk, or table. Do not place the product on an
unstable base or slanted location.
・ Place or wire the product so as to prevent the cables from being pulled or drawn.
■ Do not point the lens directly to the sun. It could degrade the imaging capability.
■ Do not look directly into the LED light. If you look directly into it at pointblank range, your
eyes may be injured.
■ If this product is used for longer than the warranty period, its performance and quality
may deteriorate due to the lifetime of its parts. For parts replacement (on chargeable
basis), consult the dealer from whom you purchased this product or our branch/office
near your location.
■ Copyright
Unless used for personal use, it is prohibited strictly under copyright law to use any photo
files without the prior consent of the copyright holder. Even if using for personal use, be
careful that there could be a situation where video or audio recording is restricted or
illegal.
■ The contents of this document are subject to change without notice. The latest version is
available from the following official website:
https://www.elmousa.com
■ It is prohibited under copyright law to use or copy any part or the whole of this document
without our prior written consent.
■ ELMO shall not be liable for any claim for damage or loss of earnings or any claim raised
by a third person due to the use, malfunction or repair of this product.

HANDLING PRECAUTIONS

The followings are special precautions against mishandling of the product. Pay close
attention to them.
①Installation
Do not place the MX-P
on an unstable place or
slanted surface.
③Carrying the MX-P
Carry the MX-P by folding the arm so as not to damage
the camera.
Do not carry by holding the arm or camera head.
Humidity：30％～ 85％(No condensation)
https://www.elmoeurope.com
②Setting up
When setting up the MX-P,
hold the body around the
operating panel.
Be careful not to pinch
your fingers.
16