Documentation; Ce Conformity; Explanation Symbols, Terms, Characteristics Of The Product; Problems And Solutions - ProfiPower 2.913.914 Mode D'emploi

GB

15. Documentation

The product has been manufactured and supplied in compliance with all relevant regulati-
ons and guidelines that are valid for all member states of the European Union. The product
complies with all applicable regulations and regulations in the country of sale. Appropriate
documents and certificates are available on request. The formal documentation includes at
least the Declaration of Conformity, the safety data sheet and the Test report of the product,
but is not limited to this.

16. CE conformity

The product complies with the following standards / directives:

17. Explanation Symbols, terms, characteristics of the product

1. Battery types
1. lead-acid battery = is an accumulator in which the electrodes of lead or lead dioxide and
the electrolyte consist of dilute sulfuric acid.
VRLA = A VRLA accumulator (English: valve-regulated lead acid battery) is a lead-acid battery
in a sealed design. GEL, AGM and MF are among them.
GEL = closed, the acid is fixed in the gel, no gases escape during charging, the system is closed
and does not allow topping up.
AGM = closed, the acid is bound in the glass fleece, there are no gases escaping during char-
ging, the system is closed and does not allow refilling.
MF = closed, the sulfuric acid flows around the lead plates directly, gases are recombined as far
as possible. Liquid is not refillable.
WET = open, the sulfuric acid flows around the lead plates directly, gases escape through the
sealing plugs. Liquid is refillable.
CALCIUM = is an accumulator in which the electrodes consist instead of lead or lead dioxide
of calcium and the electrolyte consists of dilute sulfuric acid.
2. Lithium-ion battery = A lithium-ion battery (lithium-ion battery, Li-ion battery or (seconda-
ry) Li-ion battery) is a lithium-based electrochemical power source. A further development of
the Li Ion batteries is the lithium polymer battery.
2. DC-DC
A DC-DC converter or charger, also called DC-DC converter, English DC-DC converter, refers
to an electrical circuit that converts a DC voltage supplied to the input to a DC voltage with
higher, lower or inverted voltage level.
3. AWG
American Wire Gauge, abbreviated AWG, is a coding for wire diameter. It identifies electrical
cables made of strands and solid wire and is mainly used in electrical engineering to designate
the cross section of cores.
axhess GmbH & Co. KG, Industriestrasse 11, 56598 Rheinbrohl, www.axhess.de
22
2. Generated by the device, max. Charging voltages in V according to battery type
Start
Main Charge
Trickle Charging
3. AWG (American Wire Gauge) in metric measures
(Plus the nearest British SWG)
AWG Diameter in mm Cross section
in mm*
1 7,348 42,406
2 6,544 33,634
3 5,827 26,667
4 5,189 21,147
5 4,621 16,771
6 4,115 13,299
7 3,665 10,550
8 3,264 8,367
9 2,906 6,632
10 2,588 5,260
11 2,305 4,173
12 2,053 3,310
13 1,828 2,624
14 1,628 2,087
15 1,450 1,651
16 1,291 1,309
17 1,150 1,039
18 1,024 0,823

18. Problems and solutions

Error Possible cause
Charger does not detect a charge Charger not connected
to battery
Insufficient connection
with battery poles
Battery is not a 12V battery
Battery is not charging Cables do not meet the
requirements
Battery in poor condition
Alternator does not charge
Battery can not be fully charged
Battery condition deficient
AGM/Gel SLA/WET Calcium LiON
14,3 14,0 15,0 14,0
14,7 14,4 15,4 14,4
13,5 13,5 13,5
Nearest British SWG
1
3
4
5
7
8
9
10
11
12
13
14
15
16
17
18
18
19
Remedy
Connect charger to battery
Establish a secure connection
Use 12V battery
Make sure that all cables used
meet the requirements
Check battery condition
Check alternator
Check battery condition
23
GB