Pre-Installation Instructions; Preparation Before Installing - Haier DD300RW Guide D'utilisation

Pre-Installation Instructions

This refrigerator is for built-in use only. Before use, this product must be installed
properly.
Note: Allow the unit to sit on its base for at least one hour before installation.

Preparation Before Installing

First, clean product's surface with soft cloth, remove all protective packaging
covering the product.
1. Pull the upper drawer open. Refer to the illustrations below. Remove crisper
and set aside. Then place drawer dividers to one side as illustrated.
2. With two hands, lift up on the metal drawer divider rod to remove from the
slots in the front and rear of the drawer. Once the drawer divider rod is free
from the slots(as illustrated), turn and lift as not to hit the control panel.
3. Take the drawer divider assembly out of the upper compartment and place
safely aside.
Note: After completing these three steps please close the upper drawer to avoid
damage to your person and product during installation.
English
4