Care And Decalcifying - gourmetmaxx CM-111A Mode D'emploi

EN

Care and decalcifying

ATTENTION!
• The permanent fi lter and the permanent fi lter holder are hot after use! Let
them cool off before removing them for cleaning.
• Never submerge the device, the mains cord or the plug in water.
• Prior to each cleaning, pull the plug out of the socket.
• When cleaning, do not use any corrosive or abrasive cleaners. They could
damage the surface.
1. Ensure that the device is switched off and disconnected from the power
supply!
2. Take the permanent fi lter and the permanent fi lter holder out of the fi lter
compartment and dispose of the used coffee pad/coffee grounds.
3. Clean the permanent fi lter, permanent fi lter holder and thermo cup with hot
water and, if necessary, a small amount of mild detergent.
4. Then thoroughly dry the permanent fi lter, permanent fi lter holder and thermo
cup.
5. Place the permanent fi lter and the permanent fi lter holder back in the coffee
maker once they are completely dry.
6. When needed, wipe off the coffee maker with a damp cloth and dry it with
a dry cloth.
Decalcifying
You should decalcify the device if water is only circulating very slowly or the
device is making more noise than usual during the brewing process. Use a
commercially-available decalcifi er for coffee makers for decalcifi cation.
1. Fill the water tank with a mixture of water and decalcifi er and turn the device
on. Consult the decalcifi er instruction manual to determine the correct ratio
of water to decalcifi er.
2. Let the mixture completely circulate through the device. Repeat the process
if the water still circulates slowly.
3. After you have fi nished decalcifying the device, allow water to circulate
through the device at least three times (without coffee grounds/a coffee pad)
in order to rinse the lines etc.
20