gourmetmaxx CM-111A Mode D'emploi page 19

ter the brewing process for the device to cool down before starting another
brewing process.
• Do not leave the device unattended so that you can immediately intervene in
the event of malfunctions (e.g. overfl owing etc.).
• Caution: Risk of emitted steam! Never open the water tank cover when the
device is in use! Hot steam or hot splash water may escape.
• Before start-up, make sure that the water tank cover is closed and the per-
manent fi lter as well as the permanent fi lter holder have been correctly in-
serted so that the water is able to circulate through the coffee powder/coffee
pad without any obstructions.
• Always let the coffee maker cool off for a few minutes between two brewing
processes before using it again.
• Do not add any water to the coffee maker once it has been turned on. You
could scald yourself with the sudden emission of steam.
• Never use the device with an empty water tank; the pump could be damaged
if the device is operated without water.
• Do not overfi ll the permanent fi lter to prevent the fi lter from overfl owing.
• Do not overfi ll the water tank to prevent the thermo cup from overfl owing! Al-
ways fi ll the water tank with an amount of water that the cup (thermo cup etc.)
located under the coffee spout is capable of holding!
1. Place the device on a dry, level and heat-resistant base.
2. Connect the device to a properly installed socket.
3. Open the water tank cover and add some water to the water tank.
4. Place the permanent fi lter holder in the fi lter compartment.
5. Place the permanent fi lter in the permanent fi lter holder.
6. Add a coffee pad or loose coffee grounds to the permanent fi lter.
7. Close the water tank cover.
8. Place the thermo cup (without the cover!) under the coffee spout.
9. Push the Power switch to switch the coffee maker on. The Power switch will
illuminate and the brewing process will begin immediately.
10. The brewing process is complete when no more coffee fl ows into the coffee
cup. The device automatically deactivates after the brewing process. The
Power button will go out once the device is switched off.
11. Remove the thermo cup and put the cover onto the thermo cup. The lid has
a drinking aperture. Simply push the lid cover forward or backward to open
or close the drinking aperture.
12. After use, clean the device as described in the chapter "Care and decalcifying".
19 EN