Koba Vision ZoomCam Mode D'emploi page 11

•
Check Use camera coulor change. This means that SuperNova can control the coulors of the camera, which
improves image quality.
•
TIP: Under the Settings button you can set the resolution. We recommend selecting 1920 x 1080, 60 fps. If
the picture is slow, you can lower the resolution.
•
Choose OK button.
Adjusting the viewer position and size
By default, the Viewer appears on the top half of the screen. You can change the position and size of the Viewer
through the "Connect and View" settings in the SuperNova Control Panel. You can dock the viewer to the top,
bottom, left or right side of the screen and the Viewer can be set to fill 80%, 50% or 20% of the screen area.
You can also set the Viewer to "Full Screen". While in Full Screen Mode, you can continue to use CAPS LOCK +
MIDDLE MOUSE BUTTON to switch between the Viewer and the desktop.
Switching between the Viewer and the desktop
To access the Viewer toolbar and to make adjustments to the image requires you to place the focus in the
Viewer area.
You can switch between the Viewer and the desktop by pressing CAPS LOCK + MIDDLE MOUSE
BUTTON. If you have both an active camera and whiteboard connection then pressing CAPS LOCK +
MIDDLE MOUSE BUTTON cycles you between camera, whiteboard and desktop.
Magnification
You can change the size of the image in the Viewer by using the magnification buttons in the Viewer
Toolbar. If you are using a touchscreen device, you can also change magnification by doing a 2
finger pinch or 2 finger stretch.
You can also use the following hot keys:
•
Zoom in: LEFT CONTROL + NUMPAD PLUS or CAPS LOCK + MOUSE WHEEL UP or ALT
+ EQUALS
•
Zoom out: LEFT CONTROL + NUMPAD MINUS or CAPS LOCK + MOUSE WHEEL DOWN
or ALT + DASH
Always use SuperNova in optical zoom mode. This has the best result.
This icon means you are in optical zoom mode.
KOBA Vision ZoomCam 11