Whirlpool WED85HEFW Instructions Pour L'installation page 20

Reverse door swing round-shaped door flat glass – double handle
1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been
removed from the dryer, peel the film from the dryer
door before proceeding.
Using a T25 screwdriver, remove the 4 screws securing the
®
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
2.
Move the door strike
Using a T25 screwdriver, remove the 2 screws securing the
®
door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame,
as shown.
20
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
4.
Remove hinge and latch
Using a T25 screwdriver, remove the 3 screws securing the
®
latch plate and latch backing plate and the 5 screws holding
the hinge assembly in place.
Latch
Hinge