Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Rotate and reassemble outer window
assembly to trim ring
Notches
With the edge with 2 notches at the top, align the notches
on the outer window assembly with the tabs on the trim
ring and lower into place as shown in figure A. Rotate the
outer window assembly counterclockwise to lock tabs into
place (B). Using a Phillips screwdriver, secure with 2 screws
removed earlier.
IMPORTANT: Do not overtighten.
18
7.
Remove hinge and latch
Bottom
of door
Fig. A
Using a T25
®
the latch plate and latch backing plate and the 5 screws
holding the hinge assembly in place.
8.
Reinstall hinge and latch on
opposite sides
Fig. B
Using a T25
®
backing plate, and hinge assembly on the opposite sides
from which they were removed.
Latch
screwdriver, remove the 3 screws securing
screwdriver, reinstall the latch plate, latch
Hinge
Publicité
Table des Matières
