Canon imagePROGRAF TZ-30000 Guide D'installation page 8

3
Installing the Ink Tanks
Instructions on ink tank installation are shown on the touch screen. Install the ink tanks as instructed. If the ink tank is cold, allow it to adjust to room temperature
before attaching it to the printer.
1
Open the ink tank cover.
4
Continue pulling until the entire ink tank lock lever is
tilted towards you.
●
Make sure the ink tank lock lever stays in this position.
6
Open the pouch and remove the ink tank.
2
Release the ink tank lock lever of the
color you are installing.
●
While pressing the button at the
position (B), lift up the handle part (A)
towards you.
Important
● Never touch the ink outlets or metal contacts (the area shown shaded in the diagram).
Touching these parts may cause stains, damage the ink tank, and affect print quality.
● Avoid dropping the ink tank after removing it from the pouch.
Otherwise, ink may leak and cause stains.
● Do not remove ink tanks to shake them after they have been mounted.
Doing so may cause ink to spill.
3
B
A
5
Shake each ink tank gently 7 or 8 times before opening its
pouch.
6
With it in this state, pull the ink tank
lock lever up.
Important
● Failure to shake the ink tanks may
result in reduced print quality because
ink ingredients have settled on the
bottom of the tank.