Intended Use; Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Assembling The Appliance - Profi Cook PC-ZP 1154 Mode D'emploi

Intended Use

This appliance can be used to squeeze out citrus fruit.
It is intended for the use in private households and similar
applications.
It is only to be used as instructed in this user manual. The
appliance is not intended for commercial use.
Any other use is considered improper and may result in
material damage or even personal injury.
The manufacturer is not liable for damages caused by
improper use.

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
Overview of the Components /
Scope of Delivery
1 Large pressing cone
2 Small pressing cone
3 Filter sieve
4 Juice holder with closable spout, holds approx. 350 ml
5 MAX (Maximum) marking
6 Spout with drip stop
7 Motor shaft
8 Motor housing
9 Press here to release the fruit cover
10 Lever

Assembling the Appliance

1. Push the motor shaft onto the axle until it locks into
place.
2. Put the juice holder into the motor housing.
3. Put the filter onto the juice holder.
4. Place the small pressing cone onto the motor shaft.
5. In case you want to squeeze out large fruit, place the
large pressing cone onto the small pressing cone. Pay
attention to the recesses for the wings of the small
pressing cone.
PC-ZP1154_IM
6. Fasten the fruit cover on the lever. Please pay attention
to the various recesses on the lever. The fruit cover has
to snap on.
NOTE:
The spout on the juice tank can be adjusted in two
positions.
• Snapped in facing up: The outlet aperture is closed
(drip stop).
• Snapped in facing down: The outlet aperture is open.

Electrical Connection

Check whether the power supply that you want to use
coincides with that of the appliance. The information can be
found on the nameplate.

Using the Appliance

1. Place the appliance on a firm and flat surface. Position it
such that it cannot tilt over.
2. Insert the plug in a duly installed protective contact
socket.
3. Place a glass (vessel) under the spout of the juice
container.
4. Press the spout downwards in order to open the outlet
aperture.
5. Halve the citrus fruit in the middle.
6. Hold one half of the citrus fruit above the pressing cone
with one hand, while you lower the lever with the other
hand. Put the fruit cover directly above the citrus fruit. If
you apply a little pressure to the lever, the appliance will
start the motor on its own.
NOTE:
• The juice flows into the glass (vessel). Fruit flesh
and pips remain in the filter screen.
• If you use little fruit, you can squeeze out the rest of
the fruit by pressing half of the fruit gently onto the
pressing cone with your hand.
7. Before removing the glass (vessel) press the spout
upwards in order to seal the outlet of the juice container
and prevent dripping.
8. Pull the plug out of the socket after use and clean the
appliance as described below.
NOTE:
• Citrus fruit juices should be stored in a cool place for
not more than one day.
• Never store such juices in metal containers. The acid
in the juice attacks the metal surface. Metal ions form
which spoil the taste of the juice.
31
26.03.18