Important - BQS BM01 Notice D'instruction

2. SEAT PARTS AND FITTINGS
A. Cover.
B. User manual´s poquet.
C. Ergo seat cushion for group 0
D. Harness pads.
E. Harness straps.
F. Buckle release-button.
G. Locking buckle.
H. Harness adjustment button.
I. Harness adjuster strap.
J. Child seat gradient adjuster.
K. Metal lever for angle adjustment Group 0.
L. Button for fastening seat cover.
M.Group 0 belt hook.
N. Locking clip.
O. Group 0 and 1 belt hook.
P. Harness strap slot.
Q. Harness pad connector.
R. Group 1 belt hook.
S. Metal harness connector.
3. INSTALLING CHILD SEAT. GROUP 0.
WARNIG
Do not use the child seat on a passenger seat fitted
with an active airbag.
1. Recline the seat as posible. To adjust the reclining
position of the child seat, pull the red handle
forward until you reach the required position (3.1).
2. Pull the metal lever
pull upwards releasing the lever when the stop is
reached (3.2).
3. Install the child seat rearward facing (3.3).
4. Fasten the child seat by thread the lap bel and the
diagonal belt throught the belt guide slot.Thread the
diagonal belt throught the
the back, and thread the lap belt throught the slot
M with blue arrow on the base (3.4, 3.5, 3.6 y 3.7).
Child restraint system
26
Only suitable for Group 0, approx.
0 to 9 months (0-10 Kg.)
K at the front of the base and
O slot with blue arrow on
5. Fasten the seat belt into the vehicle´s buckle until
it "clicks", making sure the child seat is properly
installed.
6. Tighten the lap belt and diagonal shoulder belt,
then place the red safety clip
shoulder belt tongue as near to the vehicle anchor
point as possible without touching it! (3.4, 3.8, 3.9
y 3.10).
Make sure the vehicle's safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle's safety belt or prevent the
installation of the seat in any way. To release your
child unbuckle the vehicle safety belt as described
in the instructions.

IMPORTANT

Ensure that the belt has no slack.
4. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Installing the child seat forward facing can only be
maid if the child is more than 9 kg.
1. To install a Group 1 seat, you must first remove the
padding for Group 0.
J
2. Pull the metal lever
pull upwards releasing the lever when the stop is
reached (4.1).
3. The seat must be in its most upright position to
adjust reclining angle of the child seat, pull the
control red handle
position is achieved (4.2).
4. Fit this child seat into the vehicle´s seat, making
sure it is firmly pressed against the vehicle seat
backrest (4.3).
BM01 Group 0/1
N on the diagonal
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
K at the front of the base and
J towards you until the desired
www.babyqs.com
EN
27