Publicité
Les langues disponibles
Les langues disponibles
Attaching the
Rubber Bumpers
Attach the two rubber
bumpers
(M)
to
the
handle side leg support as
shown using the screws
and lock nuts provided.
Table Saw
Bracket
Mounting
WARNING: To reduce the risk of injury, turn unit off,
disconnect machine from power source before assembling
the table saw to the table saw stand. An accidental start-up can
cause injury.
WARNING: For your own safety, read and understand the table
saw instruction manual before using. Failure to heed these warnings
may result in personal injury and serious damage to the table saw
and the accessory.
WARNING: The saw mounting brackets provided with this stand
are equipped with lever locks. To reduce the risk of injury, DO NOT
modify the mounting bracket lever locks.
1. Unfold the legs by
depressing
the
leg
release
levers
(F).
Rotate the legs until the
locking pin (G) clicks
into its detent (N).
2. Turn the stand upright.
The stand should be
stable and should not
rock.
3. The
M
4. Measure the distance
G
N
H
F
5. Align the holes in the
3
WARNING: Be sure that the locking pins have engaged and
the legs are firmly held in place.
locator
clip
(J)
keeps the saw from
sliding left or right during
cutting operations and
during transport. Install
the mounting brackets on
to the beam as shown by
engaging the concave
front lip of the mounting
bracket with the rounded
front edge of the beam.
One of the brackets
must engage the locator
clip (J). The mounting
bracket release levers
(E) must be positioned
to the rear of the stand as
shown.
between the mounting
holes of the table saw.
Position
the
second
mounting bracket onto
the beam at this distance
from the first mounting
bracket.
table saw base with the
slots in the saw mounting
brackets (D).
E
J
D
E
Publicité
