Troubleshooting - Xoro HSD 2200 Mode D'emploi

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Technical Support of Xoro/MAS: Tel.: 040/77 11 09 17, Internet: www.xoro.de/support.htm
Symptoms
No power The power plug is disconnected
The TV is not set to receive DVD
signal output
The video cable is not connected
No picture
securely.
The DVD video mode is not matched
with the TV
The audio cable is not connected
securely.
The power of the equipment
connected with the audio cable is
No sound
turned off.
The setting of output sound type is
not correct
The disc is dirty.
It is in fast forward or fast reverse
playback.
The playback
picture has
The copy protection effect.
occasional
No disc is inserted.
Brightness is
An un playback disc is inserted. The
unstable or noises
disc is placed upside down. The disc
are produced on
is not placed within the guide.
playback pictures
The DVD player
A menu is on the TV screen.
does not start
The parental lock function is set.
Playback.
Power supply fluctuations or other
abnormalities such as static
Buttons do not work
electricity may interrupt correct
functions.
The remote control is not pointed at
the remote sensor of the DVD player.
The remote control
The remote control is too far from the
does not work
DVD player
Properly
The batteries in the remote control
are exhausted.
No picture on
screen, a blue
picture, a running
picture, a green I/P key pressed by accident.
picture, a distorted
picture and a two-
part picture.
Cause
Connect the power plug into the wall outlet
Select the appropriate video input mode on the TV so the
picture from the DVD player appears on the TV screen
Connect the video cable into the jacks securely. Refer to
Connecting to a TV (page 10)
Connect the audio cable into the jacks.
Turn on the equipment connected with the audio cable
Set the audio setting correctly.
Eject the discs and clean it.
Sometimes a small amount of picture distortion may appear.
This is not malfunction.
Connect the DVD player to the TV directly.
Insert a disc.
Check the disc type and color system. Place the disc with
the playback side down. Place the disc on the disc tray
correctly inside the guide.
Press the SETUP button to turn off the menu screen.
Cancel the parental lock function or change the parental.
Turn the power on or off with the POWER button. Or
disconnect the power plug and insert it into the wall outlet
again.
Point the remote control at the remote sensor of the DVD
player
Operate the remote control within
about 7 m.
Replace the batteries with new ones
1) please make sure that there is no media in the drive,
because otherwise the button have no function.
2) connect the player with Scart on the TV and switch on
both devices
3) press one time the I/P button on the front of the player.
Correction
15