Publicité
Les langues disponibles
Les langues disponibles
7.3 Floating table
4
6
5
Use :
• Position the hole in the disc (4) corresponding to the part to be measured
oppositethe mark on the floating arm (5)
• Move the table on the base so that the floating arm (5) is located approxima-
tely perpendicular to the instrument measurement axes before locking it using
the locking lever (3)
• Move the part to be measured vertically towards the measurement probes
using the adjustment knob (1)
• The part to be measured can easily be positioned between the measurement
probes. The degree of freedom of movement can be reduced by moderate
tightening of the locking screw (2)
7.4 Grinding tool
• See general catalogue. (measuring benches catalogue)
Y
1
Z
2
3
X
Description
1. Height adjustment knob
(0.5mm / turn)
2. Y axis locking screw
3. Locking lever
4. Indexed hole disc
5. Floating arm
6. Location for part to be measured
7
E
Publicité
